AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Why vcds says interface not found8/9/2023 ![]() ![]() What it is important that if you try to use it after reprogramming this tool with ft232RL inside with original 10.6.0 sw. ![]() That's right but it is ept for ftdi and dump for GAL in aminebot tutorial. after plug cable into car, LED shines red and in 2-3 seconds switches to green. I downloaded and repeated all the above operations.įor each version of the program at startup I get the message: Error cable not found = -1 So I got a recommendation from ecutool(china) : please make sure use the software from (908.0 912 10.6.0)Īfter the test I get a message: interface found, Ross-Tech HEX-USB, not plugget into car. I repeated this operation on all programs available on installation disk. ![]() Plug the interface to to the car and put the ignition to ON ( not start the engine ) Installed programs, and then repeated these steps:ġ. I cleaned system from VCDS, drivers, and other.(using ccleaner)
0 Comments
Read More
Leave a Reply. |